Technical data

01750096993 E BEETLE iSPRINT POS System – Operating Manual 35
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Ensure that the adapter is installed
correctly and all cables are correctly and firmly attached. Also ensure that
the correct hard drive type is selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize the controller. Make sure that the cord is correctly and
firmly installed in the bus. Ensure that the correct hard drive type is
selected in Setup. Also check if any jumper needs to be set correctly on
the hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Cannot find or initialize the floppy drive controller. Ensure that the
controller is installed correctly and firmly. If there are no floppy drives
installed, ensure that the Diskette Drive selection in Setup is set to NONE.
Invalid EISA Configuration
PLEASE RUN EISA CONFIGURATION UTILITY
The non-volatile memory containing EISA configuration information was
programmed incorrectly or has become corrupt. Re-run EISA
configuration utility to correctly program the memory.
NOTE: When this error appears, the system will boot in ISA mode,
which allows you to run the EISA Configuration Utility.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure that the keyboard is attached
correctly and no keys are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the
error halt condition in Setup to ‘HALT ON ALL, BUT KEYBOARD’. This
will cause the BIOS to ignore the missing keyboard and continue the boot.
Memory Address Error at ...
Indicates the memory address error at a specific location. You can use
this location along with the memory map for your system to find and
replace the bad memory chips.