Manualshelf

Technical data

ManualsBrandsWincor Nixdorf ManualsComputer equipmentBEETLE AT COM Board
21222324252627282930
18 BEETLE iSPRINT POS System – Operating Manual 01750096993 E
ON/OFF Button
This is a soft touch power button that replaces the main power switch
that turns your system on and off.
From an OFF state, you can switch the system ON by simply
pressing the ON/OFF button.
From an ON state, you can also switch the system OFF by
pressing and holding the ON/OFF button for four (4) seconds.
The functions of the power button can also be altered in the Power
Management section of the CMOS setup.
RESET Switch
To perform a System Reset using the RESET switch, insert a small,
metal rod (an unwound paperclip for example) into the small hole.
POWER-ON Indicator
The indicator (LED) lights up Green when the system unit is switched
on.
HARD-DISK DRIVE Indicator
The indicator (LED) lights up Yellow when the Hard-Disk Drive of the
system unit is accessed.
Floppy-Disk Drive
The BEETLE iSPRINT system is equipped with a floppy-disk drive. The
floppy-disk driver supports a 3½” driver slot for the capacities of up to
1.44 MB.