Product manual

Connector Assignment
5
Preparing the POSBOARD for the Touch Screen
Installation
 Run the BIOS Setup utility.
Switch the system on and press «F2» key during the “Power-on-
Self-Test”.
 Choose the “Avanced” menu.
Press right or left arrow-key until “Advanced” is highlighted and
select «I/O Device Configuration» with arrow key.
Press «Enter» and select «Touch Screen Routing» with the arrow
key.
Set «Route to COM5» by using the space bar to toggle.
 Choose the “Exit” menu.
Press «ESC» twice. Select «Exit Save Changes», press «Enter»
and then choose the option «Yes» (use space bar to choose).
Accept by pressing «Enter» to save and exit the Setup utility.
 Installation of the Touchware software.
Before you start the installation of the Touchware software make
sure that previously the COM5 port has been installed in BIOS and
under Windows operating system. See section “Installation of COM
Ports” in this manual.
Install the Touchware software by using the CD delivered by Wincor
Nixdorf. The installation software will automatically detect the Touch
Controller at COM5.