User manual

BIOS Setup
45
Floppy disk controller [Enabled]
This field allows you to activate or deactivate the floppy interface.
Configuration options: [Enabled] [Disabled].
TouchScreen Routing [No Routing]
Using a TouchScreen you may select routing the touch interface to a serial
interface port using hardware lines instead of COM1, COM2 or COM5.
Configuration Options: [No Routing] [Route to COM1] [Route to COM2] [Route
to COM5].
BASE 10 address COM [230]
Configuration options: [210] [230] [250] [270]
IRQ-for COM3+4 [IRQ 10]
This Field is available only if the POS board is installed.
The interrupt lines of the serial Interfaces COM3 (I/O address 3E8h) and COM4
(I/O address 270h) are both shared and routed to IRQ10 via software
configuration. You have the options to route to IRQ10 or None. Configuration
Options: [None] [IRQ 10].
Î Refer to “PCI/PNP ISA IRQ Resource Exclusion” for appropriate IRQ-
Reserving
IRQ-for COM5 [IRQ 12]
This Field is available only if the POS board is installed.
The interrupt line of the serial Interface COM5 (I/O address 2E8h) can be routed
to IRQ5 or IRQ10 via software configuration. Configuration Options: [None] [IRQ
5] [IRQ 12].
Î Refer to “PCI/PNP ISA IRQ Resource Exclusion” for appropriate IRQ-
Reserving
IRQ-for COM6 [None]
This Field is available only if the POS board is installed.
The interrupt line of the serial Interface COM6 (I/O address 328h) can be routed
to IRQ11 via software configuration. Configuration Options: [None] [IRQ 11].
Î Refer to “PCI/PNP ISA IRQ Resource Exclusion” for appropriate
IRQ-Reserving