User manual

BIOS Setup
44
QuickBoot Mode [Disabled]
This setup node speeds up the process of booting the system a lot.
Configuration options: [Disabled] [Enabled].
I/O Device Configuration
Serial port A: [Enabled]
Base I/O address/IRQ: [3F8/IRQ 4]
Serial port B: [Enabled]
Base I/O address/IRQ: [2F8/IRQ 3]
Parallel port: [Enabled]
Mode: [Bi-directional]
Base I/O address: [378]
Floppy disk controller: [Enabled]
TouchScreenRouting: [Route to COM5]
IRQ for COM3+4: [IRQ 10]
IRQ for COM5: [IRQ 12]
IRQ for COM6: [None]
Serial port A [Enabled], Serial port B [Enabled]
These fields configure the Serial ports directly. With [Disabled] the port is
switched off. Configuration options: [Disable] [Enable]
Base I/O address/IRQ
This field sets the address with fixed IRQ for the onboard serial connectors in
combination with the interrupt used. Serial port A and Serial port B must have
different addresses. Configuration options: [3F8/IRQ 4] [2F8/IRQ 3] [3E8/IRQ 4]
[2E8/IRQ 3].
Parallel port [Enabled]
This filed has the same configuration options like the two serial ports.
Configuration options: [Disabled] [Enabled].
Mode [Bi-directional]
This field allows you to set the operation mode of the parallel port.
Configuration options: [Bi-directional] [EPP] [ECP]
Base I/O address
This field sets the address for the onboard parallel connector.
Configuration options: [378] [278] [3BC].