User manual

BIOS Setup
39
Legacy Diskette A [Disabled], Legacy Diskette B [Disabled]
These fields record the types of floppy disk drives installed in your system.
Configuration options: [Disabled] [720K, 3.5 in.] [1.44M, 3.5in.]
Primary & Secondary Master/Slave
Î Note: Before attempting to configure a hard disk drive, make sure you have
the configuration information supplied by the manufacturer of the drive.
Incorrect settings my cause your system to not recognize the installed hard
disk. To allow the BIOS to detect the drive type automatically, select [Auto].
Type: [Auto]
CHS Format
Cylinders: [ 2112]
Heads: [16]
Sectors: [63]
Maximum Capacity 1090MB
LBA Format
Total Sectors 2128896
Maximum Capacity 1090MB
Multi-Sector Transfers: [8 Sectors]
LBA Mode Control: [Enabled]
32 Bit I/O: [Disabled]
Transfer Mode: [Fast PIO 4]
Ultra DMA Mode [Disabled]
SMART Monitoring: Disabled
Type [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, the correct values will be filled in for the remaining fields
on this sub-menu. If automatic detection fails, your hard disk drive may be too
old or too new. You can try updating your BIOS or enter the IDE hard disk drive
parameters manually.
Î Note: After the IDE hard disk drive information has been entered into BIOS,
new IDE hard disk drives must be partitioned (such as with FDISK) and then
formatted before data can be read from and write on. Primary IDE hard disk
drives must have its partition set to active(also possible with FDISK).