User manual

Plugin Modules

CRT Adapter

If a CRT adapter is installed, you can connect any VGA monitor (e.g. the MO34)

to the BEETLE system via the 15-pin D-sub jack on the CRT adapter. Power is

supplied to the monitor via the rubber connector on the BEETLE, located on the

back of the housing.

PanelLink Adapter

The PanelLink adapter serves as interface for connecting BA72A, BA72A-1 or

BA73A to the D2- CPU Basic. The TFT adapter (C2-CPU) and the PanelLink

adapter (D1-CPU) must not be used on the D2- CPU Basic.

LAN 10/100 Adapter

While the LAN controller is part of the INTEL chipset the LAN adapter contains

the physical layer including Ethernet address. The LAN adapter was developed

for the D2- CPU and may be used on D2-CPU Basic as well.

PCI Submodule LAN

A PCI Onboard LAN controller (3Com; Realtek) may be used alternatively to the

LAN adapter.

PCI Submodule VGA/4 Controller

The PCI Onboard VGA/4 controller may be assembled alternatively to any other

PCI Onboard controller. It supports 2 monochrome displays, e.g. BA69 (5.7”)

and BA70 (10.4”).