User manual

BEETLE /M-II plus (BOS) User Manual 29
Push the hard disk drive carrier 1 into the position 1 of the system (hard disk
drive carrier 2 into the position 2 and hard disk drive carrier 3 into the posi-
tion 3).
Change Of Hard Disk Drive Under RAID Onboard
After the change of hard disk drive make sure that you reinitialise the actual
status of the hardware by using a RAID onboard.
Perform a new hardware scan as described:
Start  program  Intel  Intel
®
Rapid Storage Technology
You will find the following menue.
The logical assignment of the third storage medium is not the
physical mapping on the motherboard. The physical SATA port 3 is
shown as an internal connector 4.
Name of Hard
Disk Drive (1)
Hard Disk Drive-
Position 1
click here