User manual

22 BEETLE /M-II plus (BOS) User Manual
D- Sub- Jack Power Supplied (COM2*-COM4*)
The interface connection is a 9-pin D-sub jack for scanner, user or customer
displays without own power supply.
Make sure that the connector for a peripheral device is screwed
firmly to the socket to prevent possible malfunctioning. Power is
supplied via this jack.
RJ10/RMT Jack (optional)
You connect the remote (RMT) interface of your POS system via a cable to
the RMT interface of the display (BA8X). You use the RMT function by
pushing the ON/OFF button of the display.
The Remote On/Off function (RMT) enables you to wake up a BEETLE
system out of either standby/ hibernation or soft-off mode. It also puts a run-
ning system into standby / hibernation mode. The activated mode is depend-
ing on the settings of the operating system.
USB (Universal Serial Bus)- A
You can connect several USB peripheral devices e.g. scanner or scales to
the USB.
Only connect devices equipped with a shielded cable to the USB-
interface.
P-USB (PoweredUSB)
The P-USB interface is qualified for connections of peripheral devices such
as printers, barcode scanners or customer displays.
The power supply is either 12V or 24V (marked red, for POS printers).
A mechanical code avoids the plugging of a USB 12V connector into a USB
24V jack.
Always use the onboard P-USB 12V (*) to connect a BA82 or BA83
with additional options or any other multifunctional screens.