User manual

10 BEETLE /M-II plus (BOS) User Manual
Remove each of the feet.
Turn each of them to the position needed for the wall mounting, for example:
The minimum distances listed in the figure must be maintained; otherwise, a
sufficient ventilation of the equipment is not guaranteed.
The BEETLE /M-II plus (BOS) is designed for horizontal.
If you install the BEETLE /M-II plus (BOS) in vertical position, you have
attend to the following:
 Three breakable bore holes are located at the underside, which allow
the BEETLE /M-II plus (BOS) to be suspended by means of the screws.
 Mind the following minimum clearances also for vertical mounting to
ensure sufficient ventilation:
forward: 100 mm,
backward: 60 mm
sideways (left): 50 mm
 A surface made of nonflammable material (e.g. concrete or metal) must
be located underneath the vertically mounted power supply unit.