User manual

BA83 User Manual
57
Pass the cable through the cable guidance and connect it to the USB inter-
face. Put the cable loop into the housing (see big arrow).
OSD fingerprint reader
If you are going to use the USB interface at the backside of the BA83 then
connect the fingerprint reader to any free interface at the HUB. To do so,
release the cable's loop and run the cable through the strain relief.
Pass the fingerprint reader cable through the housing.
Screw the retain plate at the BA83.
Use the left borehole of the two pairs of boreholes to install the retain
plate.
Plug the jack to the connection of the fingerprint reader.