User manual

18 BEETLE /X plus User Manual
RJ10/RMT Jack (optional)
You connect the remote (RMT) interface of your POS system via a cable to
the RMT interface of the display (BA8X). You use the RMT function by
pushing the Power button of the display.
The Remote On/Off function (RMT) enables you to wake up a BEETLE
system out of either standby/ hibernation or soft-off mode. It also puts a
running system into standby / hibernation mode. The activated mode is
depending on the settings of the operating system.
D- Sub Plug (COM1)
Connect for example scales with their own power supply to the COM1
interface. COM1 is designed as a 9-pin D-sub plug.
If scales which are not supplied by Wincor Nixdorf International GmbH are
connected to the BEETLE /X plus, you must obtain a Wincor Nixdorf licence
for the driver software
Make sure that the connector is plugged securely into the socket
to prevent possible malfunctioning.
D- Sub- Jack Power Supplied (COM2*-COM4*)
The interface connection is a 9-pin D-sub jack for scanner, user or custom-
er displays without own power supply.
Make sure that the connector for a peripheral device is screwed
firmly to the socket to prevent possible malfunctioning. Power is
supplied via this jack.
DisplayPort (DP)
DisplayPort is a digital display interface developed by the
Video Electronics
Standards Association (VESA). The interface is used to connect a video
source to a display device such as a computer monitor or DVD player. The
DP jack has a the transmission of video signals with a max. resolution of
2560 x 1600 pixel.
One of the advantages over DVI is the smaller connector.