User manual

BA82 User Manual
43
Mounting On the Left Side
Proceed as described above ("Mounting on the right side"). Disconnect the
cable to connect it to the USB interface at the rear side of the monitor.
Push the bracket of the Reader into the opening of the housing, so that the
holes are lying upon each other. Then tighten it.
Pass the cable into the ca-
ble guidance of the Swipe
Card Reader and connect it.
Push the reader beneath
the bracket, so that the
screws fit into the keyhole
and the holder lays under
the clamps.
Tighten the screws.
Pass the cable through the
cable guidance and connect
it to the USB interface. If a
HUB is available you should
use one of it's USB
interfaces. Do not release
the cable loop.
Attach the cover of the
swipe card reader and push
it to the monitor until it
engages.
clamp
clamp