Technical data

2
User Information
Wincor Nixdorf (WN) does not accept responsibility for radio and TV interfer-
ence and faults that care caused by unauthorized changes that have been
made to the devices. Furthermore, cables or other devices that have not
been approved by WN may not be connected to the device. The user is
responsible for any faults and interference that are caused as a result.
Repair work on the devices should only carried out by
authorized and specially trained personnel. Improper
repairs will lead to the loss of any guarantee and liability
claims.
Extension boards with electro statically endangered
components can be identified with this label.
A certain room lighting is required, if the BA80 is also to
be used as an office terminal. Daylight has proved to be
the best.The brightness of the surrounding area and
brightness of the display screen should approximate.
Safety Instructions
This device conforms to the corresponding safety regulations for information
technology devices, including electronic office machines for use in the office
environment.
 If the device is moved from a cold environment to a warmer room where
it is to be operated, condensation could occur. The device must be com-
pletely dry before being put into operation. Therefore an acclimatization
time of at least two hours should be accounted for.
 Lay all cables and supply lines so that nobody can tread on them or trip
over them.
 Data cables should neither be connected nor removed during electrical
storms.
 Protect the device from vibrations, dust, moisture and heat, and only
transport the device in its original packaging (to protect it against impact
and blows).
 Take care to ensure that no foreign objects (e.g. paper clips) or liquids
can get into the inside of the device, as this could cause electrical
shocks or short circuits.