User manual

This will be impossible for hardware reasons! The problem is, that in such
a case on the AT bus two different hardware instances would be fighting
for the same IRQ!
Refer to the technical information about your system for the details you
need!
If you configured COM ports to share a common interrupt and ‘Permit
Share’ is not set to 1, you could use all COM ports but only one at a time.
like (only one at a time)
- open COM n
- use COM n
- close COM n
- open COM n+1
- use COM n+1
- close COM n+1 etc.
but not
- open COM n
- open COM n+1
- use COM n
- use COM n+1
- close COM n
- close COM n+1
The ‘PermitShare’ variable is specific to Windows NT. Windows 95 is
different (see below).
COM Board
GB - 16