Specifications

ENFORCER Covert PIR Camera
SECO-LARM U.S.A., Inc. 3
Overview:
Important:
Do not cut the DC jack or the female BNC
connector as this will void the warranty.
Female BNC connector
DC Plug with terminal block
Camera
Pinhole
DC Jack
Mounting bracket
Slide camera
downward onto
the mounting
bracket
Before Starting:
1. Please read this manual carefully and keep
it for future reference.
2. Use the camera within given temperature
and electrical limits.
3. Do not mount the camera where it is
exposed to rain or other moisture, or in
humid or dusty places.
4. Do not point the camera at the sun. Heat
could damage the camera, even when not in
use.
5. Do not mount the camera in areas exposed
to radiation, strong magnetic fields, or strong
electrical signals.
6. Do not open or disassemble the camera.
There are no user-serviceable parts inside.
7. Do not drop the camera or subject it to
strong vibrations.
8. For OSD programming, see separate OSD
programming manual.
Installation:
1. Run a 12VDC power supply wire and a
video cable with a male BNC connector
through the wall to where the camera will be
mounted.
2. Connect the camera’s video and power
cables.
3. Temporarily mount the camera to test its
function and display.
4. Do a preliminary test of the camera to
ensure it will work properly.
5. Program the camera if needed via the
attached OSD joystick. For OSD
programming, see separate OSD
programming manual.
6. EV-6680 Series Only: The motion-activated
LED is tied to the motion detection feature in
the OSD. To turn this feature ON or OFF,
see page 9 of the OSD manual.
7. Partially screw a screw into the wall where
the top of the bracket should go. Slide the
bracket onto the screw. Finish securing the
top of the bracket to the wall.
8. Secure the bottom of the bracket to the wall.
9. Attach the mounting bracket ball to the
mounting bracket by gently pushing the ball
into the bracket.
10. Attach the camera to the assembled bracket
by sliding the camera downward.
11. Do a final test of the video camera and
monitor.
In-line OSD joystick
Mounting bracket ball