Installation manual

ENFORCER OSD (On-Screen Display) for Covert PIR Camera
SECO-LARM U.S.A., Inc. 9
Digital Wide Dynamic Range (D-WDR):
This function will adjust the brightness value of the image for a more detailed picture.
1. Select D-WDR on the SETUP menu screen.
2. Select the desired D-WDR setting by pressing
the joystick button.
3. Select RETURN to return to the SETUP menu.
• LUMINANCE: Set the D-WDR brightness
(LOW, MID, or HIGH).
• CONTRAST: Set the D-WDR contrast
(LOW, MIDLOW, MID, MIDHIGH, or HIGH).
D-WDR OFF
D-WDR ON
Motion Detection:
This function is used to detect moving objects on-screen.
EV-6680 Series Only: The motion-activated LED is tied to the motion detection feature. Turn
MOTION DET ON or OFF to turn the motion-activated LED ON or OFF.
1. Select MOTION DET on the SETUP menu screen.
2. Select the desired MOTION DET mode by
pressing the joystick button.
• DETECT SENSE: Set detection sensitivity.
Adjustable range: 0~255.
• BLOCK DISP: Mosaic blocks will appear
where movement is present (ON, OFF, or
ENABLE). In ENABLE mode, select a certain
area in which motion is not detected. To exit
ENABLE mode, press down on the joystick for
2 seconds and then release.
• MONITOR AREA: Set detection area.
• AREA SEL: Set up to 4 detection zones.
- TOP: Set vertical start position. Adjustable range: 0~244.
- BOTTOM: Set vertical end position. Adjustable range: 0~244.
- LEFT: Set horizontal start position. Adjustable range: 0~244.
- RIGHT: Set horizontal end position. Adjustable range: 0~244.
Note: If motion detection is turned
ON for EV-6680-N3WQ and
EV-6680-P3WQ, a red LED will turn
ON every time motion is detected.