User guide

16
How to Install Quick Heal Total Security
To start with installation, insert the Quick Heal CD in the CD-Drive. CD being enabled with auto-run feature will automatically
prompt you with a list of available options.
1. Click Install Quick Heal Total Security to initiate the installation process.
Figure 1-1: Install Quick Heal Total Security
2. Installation program will first perform Pre-install virus scan on your system to scan system memory, master boot record
and system files for known viruses.
3. During Pre-install virus scan if a virus is found active in memory then follow below given procedures:
a. The installer automatically sets native scanner to scan and disinfect the system on next boot.
b. After disinfection restart your system and continue with installation. For more details refer to Native Scan in
User Guide.
4. During the Pre-install virus scan, if viruses are not found in the critical system areas then installation would proceed
further.
5. Click Next.
6. Read the License Agreement carefully; if you agree then choose I Agree. If you disagree then you cannot continue with
the installation.
7. Click Next.
8. Click Browse to change the installation path if you want to install Quick Heal in different folder.
9. Click Next.
10. You can configure additional protection related to Internet Security to ensure safe browsing. For a novice user, it is
recommended to keep the default settings intact as it will provide optimum protection against malwares and various
threats.
11. Click Next.
12. Read the important information relating to the product.
13. Click Next.
14. On Finish, Registration/Re-activation, Updating and Install Quick Heal Firewall activities will be performed. In
case if you wish to perform these activities later on then unselect the above options and click Finish.