Product Manual

Page 2 of 4
006065 Rev O Date 06-06-12 JWC
5. With table in the upright position, adjust the four (4) Adjustable Glide Feet to level the table.
6. Use a Phillips bit screwdriver and a 7/16” wrench to check all screws, nuts, and bolts to ensure they are tight
and did not loosen during shipping.
7. Load paper roll onto Paper Holder Rod. Rod must be inse rted through Paper Rod Clamps.
Vinyl Strap Adjustment – Should the vinyl strap on your Winco table need to be adjusted, unscrew the scre w and
washer that currently holds either side of it in place. Pierce another hole in the strap to give desired tensi on and
re-insert scre ws.
You may move the strap to a new location by removing the screws in end s of the vinyl strap and re-installing in the
new location. (It may be necessary to drill 1/16” pilot holes in the wood table bottom to ease re-installation of
screws.)
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Do not over tighten nuts and bolts. Periodically check all fas teners for tightness.