Owner's manual

Page 4
60706-198
1004-00
WARNING: Personal Injury & Equipment Damage
TRAILER MAY TIP OVER AND CAUSE INJURIES IF
WHEELS ARE NOT SPACED FAR ENOUGH APART.
C. The trailer height and mounting position of the generator on
the trailer should enable aligning the drive shaft (tumbling bar)
in a straight or nearly straight line between the power take-off
and generator input shafts. Misalignment must be less than
15 degrees during generator operation, even though the
mechanical design of the tumbling bar would allow greater
misalignment.
D. The generator mounting area of the trailer bed should be
flat. All four generator mounting pads must rest firmly on the
trailer bed. Install shims if necessary to even out the bed
under the mounting pads, then bolt the generator firmly in
place.
Typical Connection Methods for Generator Power Service
Figure 5