User Manual

313028-02 16199-024I

Remove the generator from the pallet and block generator up 8 to 10 inches to

gain access to the bottom of the cradle assembly. A lifting jack or hoist may also

be used if available.

•

STEP 2

STEP 3

Cut the foam strip (ref. 20) in half using a scissors. Apply to the underside of the

handle supports (ref. 1 & 2). Insert hole plugs (ref. 16) into the ends of the handle.

Bolt left and right handle supports (ref. 1 & 2) to the cradle using hardware on the

cradle. Attach handle (ref. 7) using hardware (ref. 9, 10, 11, 14). Do not over-

tighten so that the handle will move freely.

•

LOOSEN BOLTS TO CREATE

A GAP BETWEEN THE SIDE

RAIL AND WASHER. THEN

SLIDE HANDLE BRACKET IN

BETWEEN AND RETIGHTEN

BOLTS.