User Manual

113028-02 16199-024I

INSTALLATION INSTRUCTIONS

4 WHEEL DOLLY KIT

COMPONENT LIST

REF. # PART # DESCRIPTION QTY.

1 300066-13 Left Handle Support 1

2 300066-12 Right Handle Support 1

3 15775-007 Front (Engine) Axle Bracket 1

4 15775-006 Rear (Gen-end) Axle Bracket 1

5 64326-020 Axle 2

6 SEE NOTE BELOW 43657-008 Hard Rubber Wheel & Tire 4

7 61857-007 Handle 1

16199-124

Parts Bag 1

NOTE: Pneumatic Wheel & Tire. 43657-003 (optional)

PAGE 1
INSTALLATION INSTRUCTIONS 4 WHEEL DOLLY KIT 3 4 6 1 2 7 5 COMPONENT LIST REF. # PART # DESCRIPTION QTY. 1 300066-13 Left Handle Support 1 2 300066-12 Right Handle Support 1 3 15775-007 Front (Engine) Axle Bracket 1 4 15775-006 Rear (Gen-end) Axle Bracket 1 5 64326-020 Axle 2 6 SEE NOTE BELOW 43657-008 Hard Rubber Wheel & Tire 4 7 61857-007 Handle 1 16199-124 Parts Bag 1 NOTE: Pneumatic Wheel & Tire.
PAGE 2
STEP 1 • Open hardware bag and separate components. FASTENERS & MISC.
PAGE 3
STEP 2 • • Cut the foam strip (ref. 20) in half using a scissors. Apply to the underside of the handle supports (ref. 1 & 2). Insert hole plugs (ref. 16) into the ends of the handle. Bolt left and right handle supports (ref. 1 & 2) to the cradle using hardware on the cradle. Attach handle (ref. 7) using hardware (ref. 9, 10, 11, 14). Do not overtighten so that the handle will move freely. 7 14 9 16 2 11 10 LOOSEN BOLTS TO CREATE A GAP BETWEEN THE SIDE RAIL AND WASHER.
PAGE 4
STEP 4 • Bolt Front Axle Bracket (ref.3) on the engine end of the cradle and Rear Axle Bracket (ref.4) to the generator end of the cradle using hardware (ref. 17, 21, 18, 19). Make sure the axle brackets are on the inside of the cradle cross-members. The flat washers (ref. 21) go onto the bolts (ref. 17) first. 19 18 4 17 21 3 STEP 5 • • Place spacer (ref. 15), washer (ref. 12), wheel (ref. 6), washer (ref. 12) on the axle. Then tab the hubcap (ref. 13) on the axle.