Instructions ULPSS12H2W/E Owner manual

10. Locate the 2-wire white connector, hanging
loose on the right hand side of the control tower.
Attach it to the matching connector “H” on the
bottom of the new controller “F”. **
**If left disconnected the unit will start then shut
down.
11. Replace the circuit breaker cover
panel “E” and re-install the 2 bolts “B”.
12. Remove the left side door.
13. Locate the 2-wire white connector on the left side of the engine. Unplug the white
connector and tie back if necessary. See picture below.