Manual

REMOVAL AND INSTALLATION OF BOLT

ASSEMBLY FROM THE RECEIVER

Note: Verify that gun is unloaded before beginning this

procedure by placing the ramrod down the barrel until it

touches the breech plug. If gun is unloaded, the end of

the ramrod should be flush with the crown of the muzzle.

If rod extends beyond the crown of the muzzle, assume

the rifle is loaded and that it should be unloaded before

proceeding.

BOLT REMOVAL

1. Cycle the Bolt Handle to the open and back position.

Then, as per arrow “A”, press down on the bolt

handle (Figure 2).

2. Maintaining downward pressure on the bolt handle

(as described in step 1), pull the bolt assembly

rearward, as per arrow “B” in Figure 3. The entire

bolt assembly will now pull free from the receiver.

FIGURE 2

FIGURE 3

“A”

➔

“B”

➔