Manual

shooters is “cast on.” Shims marked 1R1L, 2R2L, and

3R3L, will all adjust drop at comb the same amount as

shims 1, 2 and 3, and will also adjust the cast right or

left approximately

⁄8". You will notice that the two

opposing edges of these spacers are different in thickness.

These shims with their respective stamps are further

clarified here:

Shim 1R1L adjusts the comb in the increment given

above, (shim 1) and will adjust the cast on or cast off

approximately

⁄8”. For right-handed shooters, install this

shim between the receiver and the stock with the R

facing the end of the buttstock, so its thicker side is on

the left side. This casts the stock slightly to the right,

away from the face of a right handed shooter. If you turn

the shim around so the L is facing the end of the

buttstock, and it will cast the stock to the left.

Shim 2R2L adds the same amount of cast to the stock as

shim 1RL and the same amount of drop to the comb as

shim No. 2.

Shim 3R3L adds the same amount of cast to the stock as

2RL and 3RL, and lowers the comb approximately

⁄16"

and the heel approximately

⁄8".

TO INSTALL A SHIM —

1. COMPLETELY UNLOAD YOUR SUPER X3 SHOTGUN.

INSPECT THE CHAMBER, FEED MECHANISM AND

MAGAZINE TO MAKE SURE THEY DO NOT CONTAIN

ANY SHELLS.

2. Use a #2 cross tip or Phillips screwdriver to remove the

recoil pad at the end of the buttstock (Figure 15). Place

a small amount of petroleum jelly on the screw access

FIGURE 19

Fit the shims to the

buttstock.

FIGURE 18

Use a socket to

remove the nut

that holds the

buttstock in place.