Manual

22
provided to extend length of pull
3
⁄4". With longer screws
(not provided), more than three spacers can be added to
further extend length of pull.
Composite stocked models come from the factory with
two spacers in the box. Wood stocked shotguns come
with a
1
⁄4" thick spacer installed. Additional spacers can
be ordered through your local Winchester Rifles and
Shotguns dealer or by calling our Customer Service
Department at [phone].
Length of pull can be further shortened by having a
gunsmith trim the stock and refit the recoil pad.
Composite stock guns can be trimmed up to
1
⁄2".
Shotguns with a composite stock also feature a shim
adjustment system that allows fine tuning of drop at
comb, heel and cast. Six shims are included.
TO ADJUST LENGTH OF PULL —
1. COMPLETELY UNLOAD YOUR SUPER X3 SHOTGUN.
INSPECT THE CHAMBER, FEED MECHANISM AND
MAGAZINE TO MAKE SURE THEY DO NOT CONTAIN
ANY SHELLS.
2. Use a #2 cross tip or Phillips screwdriver to remove the
recoil pad at the end of the buttstock (Figure 15). Place
a small amount of petroleum jelly on the screw access
slits on the top and bottom of the rear of the buttstock
to prevent damaging the recoil pad. Insert the
screwdriver into each of the two access holes. Make
certain the tip of the screwdriver engages the head of
the screw. Turn the screw counterclockwise until the
screw is completely loose from the stock. When both
screws are free, remove the recoil pad.
FIGURE 15
Locate the two slits in the recoil pad
and loosen the screws that hold the
recoil pad in place.
FIGURE 16
The stock spacers fit
between the recoil pad
and buttstock. With the
included screws,up to
three spacers can be
used to increase length
of pull.