Manual

window on the magazine tube — with a screwdriver
while keeping your free hand on the magazine spring
retainer (Figure 12). Slowly remove the magazine
spring retainer as it is under pressure of the magazine
spring (Figure 13).
5. As the spring pushes the retainer out of the tube the
plug will come with it. Remove the retainer, the plug
and the magazine spring from the magazine tube.
6. Remove the plug from between the retainer and the
magazine spring (Figure 14).
INSTALLATION —
1. Depress the magazine spring back into the magazine
tube and replace the magazine spring retainer over the
top of the spring.
21
2. Align the magazine retainer tab with the rectangular
slot in the magazine tube. Push the magazine spring
retainer down into the magazine. Make sure the
magazine spring retainer tab is locked in place in its
retaining slot in the magazine.
3. Reinstall the barrel (if it was removed), the forearm and
then the magazine cap as explained under
“Initial Assembly/Takedown” on page 10.
In the future, should you wish to limit your firearm to
three shots again, unscrew the magazine cap, remove the
forearm and remove the magazine spring retainer as
explained previously. Hold the spring down inside the
magazine tube and insert the tapered end of the plug
inside the spring. Lightly press the front end of the plug
to force the magazine spring into the magazine until the
base of the plug is level with the end of the magazine
tube. Replace the magazine spring retainer, forearm and
magazine cap. Make sure the magazine follower remains
in place inside the rear of the magazine tube.
STOCK ADJUSTMENT
The stock of the shotgun can be adjusted for length of pull
by adding or removing spacers to the rear of the stock.
This feature applies to both wood and composite stock
models. Each spacer extends length of pull
1
⁄4" and a
maximum of three spacers can be added with the screws
FIGURE 14
Remove the plug from the end
of the magazine spring.