Manual

THE "ON" POSITION, AND THEN PLACE
THE HAMMER INTO THE REBOUND,
POSITION UPON CLOSING THE ACTION.
LOADING THE MAGAZINE
—
The magazine is loaded through the port on the right
side of the receiver.
1. With the action closed and the safety (manual
hammer stop) in the “on” position and the hammer
in the rebound position, press the spring cover inward
with the tip of the first cartridge until all but the rim
has entered the loading port (See Figure 11A & B).
2. Then, insert the next cartridge in the same man-
ner, pushing the preceding cartridge into the maga-
zine.
3. Repeat this procedure with each cartridge, but
push the last cartridge past the end of the spring
cover, allowing the cover to snap closed
(see Figure 12). Do not exceed the recommended
capacity of the magazine.
BEFORE LOADING, ALWAYS MAKE SURE
TO ALWAYS PLACE THE SAFETY (MANU-
AL HAMMER STOP) IN THE "ON" POSI-
TION, AND THE HAMMER IN THE
REBOUND POSITION.
CAUTION: ALWAYS MAKE SURE THE CAR-
23
Then return it upward to it’s original position (see
Figure 10). Keep you fingers clear of the trigger at all
times when working the lever.
IN EITHER CASE, ALWAYS FIRST PLACE
THE SAFETY (MANUAL HAMMER STOP) IN
22
Push the last cartridge fully in until the cover
closes.
F IGURE 12
F IGURE 11B
Push in until almost fully inside the loading gate, then
start another cartridge. Push the last cartridge fully in
with your thumb.
Carefully start the cartridge into
the loading port
F IGURE 11A
Return the action
to the closed
position by work-
ing the lever back
and fully up
F IGURE
10