Manual

IN EITHER CASE, ALWAYS FIRST PLACE
THE SAFETY (MANUAL HAMMER STOP) IN
THE "ON" POSITION, AND THEN PLACE
THE HAMMER INTO THE REBOUND,
POSITION UPON CLOSING THE ACTION.
LOADING THE MAGAZINE —
The magazine is loaded through the port on the right
side of the receiver.
1. With the action closed and the safety (manual
hammer stop) in the “on” position and the hammer
in the rebound position, press the spring cover inward
with the tip of the first cartridge until all but the rim
has entered the loading port (Figure 11A & B).
2. Then, insert the next cartridge in the same manner,
pushing the preceding cartridge into the magazine.
3. Repeat this procedure with each cartridge, but
push the last cartridge past the end of the spring
cover, allowing the cover to snap closed (Figure 12).
Do not exceed the recommended capacity of the
magazine.
BEFORE LOADING, ALWAYS MAKE SURE
TO ALWAYS PLACE THE SAFETY (MANUAL
HAMMER STOP) IN THE “ON” POSITION,
AND THE HAMMER IN THE REBOUND
POSITION.
23
Push the last cartridge fully in
until the cover closes.
F IGURE 12
02-079-WFA_1892_om_revision 7/17/03 10:05 AM Page 25