Manual

BARREL. AS EXPLAINED PREVIOUSLY,

BEFORE LOADING YOUR RIFLE MAKE

SURE ALL GREASE AND OIL HAS BEEN

REMOVED FROM THE BARREL AND

CHAMBER, AND THERE ARE NO

OBSTRUCTIONS IN THE BARREL OR

ACTION AREAS.

LOADING THE CHAMBER —

The chamber may be loaded two ways. Before

attempting any loading procedure:

MAKE SURE THE BARREL IS POINTED

IN A SAFE DIRECTION AND THAT THE

SAFETY (MANUAL HAMMER STOP) IS IN

THE “ON” (SAFE) POSITION AND THE

HAMMER IS IN THE REBOUND POSITION.

• Load the chamber by placing a cartridge directly

into the chamber through the opened action. This is

for single shot loading only with the magazine empty.

To do this, open the action by operating the finger

lever fully down and forward. Insert a round into the

chamber then close the action.

• Load the chamber by transferring a cartridge that

was previously loaded into the magazine to the

chamber by operating the finger lever. To cycle the

lever , pull it downward and fully forward with the

IGURE

Cycle the lever downward and fully forward to open

the action.

02-079-WFA_1892_om_revision 7/17/03 10:04 AM Page 23