Manual

To place the safety (hammer stop) in the “off” position:
First, point your rifle in a safe direction, then push
the safety fully forward, covering the “S” inscribed on
the rifle, and exposing the red warning dot. When
the red dot is visible below the safety it is in the “off”
position (refer again to Figure 6-B). The safety can be
actuated with the hammer in the rebound or cocked
position.
LOWERING THE HAMMER —
At any time the hammer can be cocked either
manually or by cycling the finger lever fully. Unless
shooting is imminent it is important to lower the
hammer immediately to the rebound position from
the cocked position. To do this:
1. MAKE SURE THE BARREL IS POINTED
IN A SAFE DIRECTION AND THAT THE
SAFETY (MANUAL HAMMER STOP) IS IN
THE “ON” POSITION.
2. Get a stable grip on your rifle with your hand in
shooting position. Place your thumb on the hammer
and firmly hold the hammer back slightly with your
thumb.
3. While holding the hammer back with your thumb,
apply just enough pressure on the trigger to release
the hammer from the full-cock position (Figure 7).
17
F IGURE 6B
Safety in the off safe (fire) position. Pushed forward.
02-079-WFA_1892_om_revision 7/17/03 10:04 AM Page 19