Manual
7. Replace the valve assembly back onto the
magazine and turn until "hand tight".
~
~l~"'~~~ HOW TO LOAD
-
USE THE COR-
T RECT AMMUNITION REFERENCED
BY THE INSCRIPTION ON THE BARREL.
BEFORE LOADING YOUR GUN BE SURE
ALL GREASE AND OIL HAS BEEN RE-
MOVED FROM THE BARREL AND CHAM-
BER, AND THERE IS NO OBSTRUCTION.
1. Pull the cocking handle all the way back
until the breech bolt latches open.
~l~'N~~~2. PLACE THE SAFETY IN THE "ON"
T POSITION. The chamber can now be
loaded by inserting a shell directly into the
ejection port.
--=l -
-
~;\-
~l~'N~~~ 3. KEEP YOUR FINGERS CLEAR OF
T THE EJECTION PORT and press the
action release button on the under side of
the receiver. The action will snap closed
placing the shell in the chamber. The gun is
now ready to be fired single shot.
~l~"'~~~ 4. LOADING THE MAGAZINE-
T WITH THE SAFETY IN THE "ON" PO-
SITION and the action closed, push the shot
shell upwards against the carrier and for-
ward into the magazine. There will be a
"click" as the cutoff (the part that holds the
shell in the magazine tube) snaps into
position.
5. Repeat the previous step to load the sec-
ond shell into the magazine tube, again mak-
ing sure the cutoff has snapped into position.
~ TO UNLOAD THE CHAMBER AND
T MAGAZINE
-
BE SURE THE SAFETY
IS IN THE "ON" POSITION (THE RED WARN-
ING BAND MUST NOT BE VISIBLE).
1. Pull the cocking handle all the way back,
extracting and ejecting the shell from the
chamber.
2. Release the cocking handle allowing the
bolt to close. Repeat this operation until the
gun is empty. After the last shell is ejected
the breech bolt will latch in the open position.
~ IMPORTANT-ALWAYS VISUALLY
T CHECK AND KNOWFOR SURE THAT
YOUR GUN IS NOT LOADED, BY VIEWING
BOTH THE CHAMBER AND THE MAGAZINE
THROUGH THE OPEN ACTION.
ALTERNATE WAY TO UNLOAD -
The shells
can be removed from the magazine first by:
~~~'N~~~ 1. PLACE THE SAFETY IN THE "ON"
T POSITION.
2. Turn the gun over so the trigger guard is
up, then push the carrier down as far as it
will go.
.
3. Push inward on the cartridge cutoff on the
right releasing the shell from the magazine.
Press the cutoff again to release the second
sh!3l1.