'-"f"oI:tI ,.. ,., WARNING SAFETY WARNING: Failure to obey a safety warning may result In Injury to you or T to others. INSTRUCTIONS FOR THE MODEL 1400 ~ CAUTION-ALWAYS KEEP THE T MUZZLE POINTED IN A SAFE DIRECTION. Prior to using live ammunition, familiarize yourself thoroughly with these operating instructions.
7. Replace the valve assembly back onto the magazine and turn until "hand tight". 4. LOADING THE MAGAZINEWITH THE SAFETY IN THE "ON" POSITION and the action closed, push the shot shell upwards against the carrier and forward into the magazine. There will be a "click" as the cutoff (the part that holds the shell in the magazine tube) snaps into position. ~l~"'~~~ T ~ ~l~"'~~~ HOW T TO LOAD - USE THE COR- RECT AMMUNITION REFERENCED BY THE INSCRIPTION ON THE BARREL.
-- 4. WITH THE SAFETY STILL IN THE "ON" POSITION, pull the cocking :;1~'N~~~ ~ handle all the way back to remove the shell from the chamber. ~ HOW TO FIRE - WITH THE SAFETY 4. To remove the barrel, slide the barrel and forearm forward as a single unit until the forearm clears the end of the magazine tube. ~ "ON" load your gun as previously instructed. When ready to shoot, firmly shoulder your gun and push the safety to the "off" position exposing the red warning ring.
be lifted out or slid out the front of the receiver. For routine cleaning no further dismantling is necessary. TO REINSTALL THE BREECH BOLT ASSEMBLY 3. Lift trigger group out of receiver by pulling on trigger guard. 4. Do not pull trigger after disassembly. 5. Remove the ejector (the flat spring like piece that fits along the inside wall of the receiver) by bending the rear section of the ejector inward just enough to disengage the small retaining pin in the side of the receiver.
~ TO REINSTAll THE TRIGGER GUARD ASSEMBLY 1. With the hammer cocked and the SAFETY ON place the forward end of the guard assembly into the receiver. Locate the slide HAMMER '>I ~ supports (the flat bars on the sides of the assembly) into the mating notches in the throat of the magazine. 2. Pivot the rear of the guard into the receiver and insert the trigger guard pin into the right side of the receiver. TEN COMMANDMENTS OF FIREARMS SAFETY A good hunter is a safe hunter.
60 -:A filii"'" ~ 61-" 502 27 " \.,'~ \' 3 \ )?' i 24 28 \ ,~~'" 26 .\\",\\,\\" ! Y' {I' 19 33 ~~A1-~," ",-;t:;..., I I J~ 11. 1 16-\ ~ '-56 . ~ 20- 21- / ~:::::, ~~49 ~~ MODEL 1400 NOMENCLATURE Parts may be ordered directly from Winchester Product Service Dept. Please specify part number, part name, serial #, gauge, chamber length, and grade (Le., Field, V.A., etc.).