Manual
CAUTION: WHENEVER HANDLING ANY SHOT-
GUN FOR THE PURPOSE OF REMOVING OR
INSTALLING A CHOKING DEVICE, MAKE
ABSOLUTELY CERTAIN THE GUN IS FULLY
UNLOADED, AND THE ACTION IS LOCKED
OPEN! NEVER ATTEMPT TO REMOVE OR
INSTALL A SHOTGUN CHOKING DEVICE ON A
LOADED FIREARM!
DO NOT FIRE THIS SHOTGUN WITHOUT HAV-
ING THE WINCHOKE CHOKE TUBE
INSTALLED. PERMANENT DAMAGE MAY
RESULT TO THE THREADS.
FAILURE TO FOLLOW THESE WARNINGS MAY
CAUSE DAMAGE TO YOUR GUN AND CAUSE
INJURY TO YOURSELF AND OTHERS.
TUBE REMOVAL
1. Fully unload your Model 1300. Place the safety in
the “ON SAFE” position.
ALWAYS UNLOAD YOUR MODEL 1300 COM-
PLETELY. INSPECT THE CHAMBER, MAGA-
ZINE AND FEED MECHANISM TO MAKE SURE
THEY DO NOT CONTAIN ANY SHELLS.
2. Open the action.
3. Use the WinChoke spanner wrench to loosen the tube,
turning it counterclockwise (see Figure 14). Finger twist
the tube the rest of the way out of the barrel.
SHOT CONVERSION CHART
Lead Steel
Full *
Improved Modified Full
Modified Full
Improved Cylinder Modified
Skeet Improved Cylinder
Cylinder Cylinder
*not for use with steel shot
Use the spanner tool to remove or
tighten WinChoke tubes
FIGURE 14
23