Manual
HOW TO REASSEMBLE THE FIRING PIN, BREECH BOLT
AND SLIDE
. (20 GAUGE ONLY)
1. Reinstall the firing pin spring over the firing pin. Either
end can go on first.
2. Insert the firing pin (with spring) into the rear opening
of the bolt slide, pin end first.
3. To reinstall the bolt assembly on the slide arm bridge
push or compress the “knob end” of the firing pin suffi-
ciently into the hole in the bolt slide so that the large space
between the grooved “knob” and the flange on the firing
pin is centered in the round hole in the bolt slide.
4. Place the curved tongue, located on the slide arm bridge,
into the space between the knob and flange and slowly
release pressure on the end of the firing pin . Let the flange
on the pin pull the tongue toward the rear of the bolt
assembly. This should hold the breech bolt assembly and
the slide arm bridge together during further assembly.
5. With the trigger guard group removed, insert the bolt
assembly through the trigger guard opening up into the
receiver. The front face and extractor of the bolt assembly
should be facing the barrel or front of the shotgun. The
slide arm bridge should be facing down toward the trigger
guard group opening.
6. While holding the bolt assembly in place, insert the
slide arm bars into the breech and connect them to the
slide arm bridge.
HOW TO REINSTALL THE TRIGGER GUARD GROUP.
Be careful when reinstalling the trigger group. Never force
parts into position. Normally the bolt assembly, slide arms
and barrel should be attached before installing the trigger
guard group. The hammer should be in the cocked posi-
tion and the safety in the “ON SAFE” position. Carefully
insert the trigger guard group into place. It may be neces-
sary to slide the forearm into different positions until the
trigger guard group fits flush into the receiver. When it is
properly installed it will fit easily and the pin will slide in
without excessive force.
Installing the bolt assembly after the trigger guard group is
installed should not be attempted. Consequently, make
sure you have already installed the bolt assembly before
installing the trigger guard group. It is not necessary that
the barrel already be attached to install the trigger group.
Install the trigger group by as follows:
1. Turn your shotgun over with the open bottom of the
receiver facing upward. Hold the trigger guard group at an
angle to the receiver (about 45 degrees) and then engage
the front tabs on the trigger guard group with the corre-
20