Manual

tact your local Service Representative or U.S. Repeating
Arms Co.
HOW TO REASSEMBLE THE FIRING PIN, BREECH BOLT
AND SLIDE
. (12 GAUGE ONLY)
1. Reinstall the firing pin spring over the firing pin. Either
end can go on first.
2. Insert the firing pin (with spring) into the rear opening
of the bolt slide, pin end first.
3. To reinstall the bolt assembly on the slide arm bridge
push or compress the “knob end” of the firing pin suffi-
ciently into the hole in the bolt slide so that the large
space between the grooved “knob” and the flange on the
firing pin is centered in the round hole in the bolt slide.
4. Place the curved tongue, located on the slide arm
bridge, into the space between the knob and flange and
slowly release pressure on the end of the firing pin. Let
the flange on the pin pull the tongue toward the rear of
the bolt assembly. This should hold the breech bolt
assembly and the slide arm bridge together during further
assembly.
5. With the firing pin and breech bolt now assembled,
engage the slide arm bridge into the matching cuts on the
slide arms (see Figure 11).
6. Hold the slide arms and bolt/slide arm bridge assemblies
together. Start the forearm assembly onto the magazine
tube.
7. Remove the magazine cap and carefully guide the slide
arms and bolt/slide arm bridge assemblies into the front of
the receiver. As the assemblies enter the receiver, slide
them fully rearward (see Figure 12).
19
FIGURE 12
Carefully guide the bolt
assembly — on the slide
arms — into the receiver.
FIGURE 11
Position the bolt assembly on the
slide arms.