Manual

care of your
model II
Your WINCHESTER Model 12 is world-
famous as "The Perfect Repeater." As with other
top quality products, proper care will guarantee
its long life and smooth, efficient operation.
Neglect is the great spoiler of firearms. Rain,
snow and dampness are constant threats to
barrels, actions, magazines and all metal parts.
Perspiration from your hands is a major cause
of rusty exterior surfaces. Good judgment and
proper equipment, however, will eliminate
danger.
Although modern ammunition will not dirty
or foul barrels and actions, dampness CAN.
After shooting in bad weather, wipe out the
bore of your Model 12 with an oily patch and
cover exposed surfaces with a thin film of oil.
The action should be cleaned after exposure
to rain, snow or salt spray and a film of oil
applied. This is made easy in your Model 12
through an exclusive feature which permits you
to easily remove the trigger assembly, including
hammer and carrier, by taking out one screw
located in the lower tang at the rear of the
trigger guard.
When storing, apply gun grease to all exposed
surfaces, then place your Model 12 in a gun
case, if available. Store in a dry place. Do not
plug the muzzle with any obstruction. Before
firing, be certain that all grease is wiped from
the arm, especially the bore.
Should your WINCHESTER Model 12 ever
need repairs, return it to the WINCHESTER
factory where it will receive the same careful
attention and care used in its manufacture.
WINCHESTER-WESTERN DIVISION
NEW HAVEN 4, CONNECTICUT
OLIN MATHIESON CHEMICAL CORPORATION
lin
LITHO U.S. A.
FORM NO. 2194