Manual

2. Remove both
screws at front end
of magazine hold-
ing top of metal
magazine plug to
prevent its sudden
ejection.
2. Draw down the
adjusting sleeve
lock, disengaging
the notches with
those on the adjust-
ing sleeve.
3. Allow metal
magazine plug and
magazine spring to
slowly extend to
spring's full length
then lift out spring
and remove wooden
plug from maga-
zine tube.
3- Turn adjusting
sleeve one notch in
direction of arrow
to tighten. Turning
in other direction
will loosen the joint.
*7
4. Replace spring
in magazine, maga-
zine plug, magazine
plug screws and
locking pin.
1- Remove adjust-
ing sleeve lock
screw "C" in right
side of receiver ex-
tension face.
4. Push adjusting
sleeve lock back in-
to place and replace
lock screw. If the
barrel is still loose,
repeat procedure.
to Tighten Model 12
Take Down
Unusually frequent taking down and
reassembly of your Model 12 may, after
a long period, result in some looseness
of the barrel, in the receiver. This con-
dition is unlikely, but, in any event
can be easily corrected.