SPECIAL SUPPLEMENT Licensee Winchester Super X2 Sporting Shotgun Supplement to Owner’s Manual
WINCHESTER SUPER X2 SPORTING sporting clays, skeet and general trap shooting and other competition. The design is built on the reliable Super X2 platform with features to help your range scores. The Super X2 Sporting is supplied with five Invector-Plus™ choke tubes, two interchangeable gas pistons and six spacers to adjust the comb, heel and cast of the buttstock.
1. Open the action of your shotgun until it locks back. 2. Carefully remove the forearm from the magazine tube by unscrewing the magazine cap and sliding the forearm forward off the magazine tube. FIGURE 1 Piston #1, Light DO NOT SQUEEZE HARD ON THE OPEN REAR END OF THE FOREARM. TOO MUCH PRESSURE COULD CAUSE THE WOOD TO SPLIT. 3. Remove the barrel, then exchange the gas piston. The gas piston sits on top of the gas piston sleeve with the taper of the piston toward the muzzle.
FIGURE 2 FIGURE 3 Stamp Remove both screws from the buttstock. One spacer comes already installed on the gun. Five extra spacers are provided for custom adjustments. 2 Neutral. This spacer is already installed on your Super X2 shotgun. It sets drop at comb at 11⁄2", and heel at 23⁄8". The drop measurement of the comb is determined by measuring the distance between the plane formed by the top of the rib and the forward most point of the cheek piece.
FIGURE 5 FIGURE 4 Make sure the spacer is in the proper position before re-attaching the buttstock. Loosen the stockbolt nut and remove the stockbolt washer and plate. have you looking directly down the center of the rib with the front and middle beads in alignment. shooters, install this spacer with the R facing out, toward the end of the buttstock, so its thicker side is on the left side of the receiver. This casts the stock slightly to the right, away from the face of a righthanded shooter.
TO INSTALL A SPACER: FIGURE 6 Use a cross tip or Phillips screwdriver to remove the recoil pad at the end of the buttstock. Lubricate the screw holes with petroleum jelly to prevent marring the pad with the screwdriver. Work the screwdriver tip into the two access holes in the pad, top and bottom. Make certain the tip of the screwdriver securely engages the head of the screw, then turn counterclockwise. Remove both screws, taking care not to scratch or mar the buttstock (Figure 3).
PARTS, SERVICE AND REPAIR For service, repair and parts information call for the location of the Authorized Repair Center near you: 1-800-322-4626, or contact us at: Winchester Firearms 3005 Arnold Tenbrook Road Arnold, MO 63010 For general questions or comments, or to obtain a complete Super X2 owner’s manual call toll free: 1-800-945-5237. For additional information go to the Winchester Firearms web site at: www.winchesterguns.com.
Winchester trademarks licensed from Olin Corporation.
