WinBook 10.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
RF Exposure Information (SAR) This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.
Tablet layout No. Name No. Name 1 Front facing camera 6 Headphone plug 2 Touchscreen 7 Micro HDMI port 3 Windows button 8 Micro USB 2.0 DC IN 4 USB 3.
No. Name No.
Charging your tablet If your tablet is just being unpacked from the box, you need to charge the tablet first. It will take around 4 to 5 hours to be fully charged. 1. Plug the USB head of the cable into the adapter. 2. Plug the micro-USB head of the cable into the micro-USB port on your tablet. 3. Plug the adapter into a wall-socket.
Powering ON/OFF your tablet To power on your tablet Press and hold the power button down until the screen turn on. To power off your tablet Press and hold the power button for at least four seconds, and you will see an instruction appears in the middle of the screen, which is as shown below. Slide your finger on the screen downward, and the system will power off itself.
Inserting a storage card Your tablet supports micro-SD cards with storage space 64G (Max). You can insert the micro SD card and pull it out without powering down the tablet. To do so, follow the steps below. Install your Micro SD Card 1. Hold your tablet with front side up. 2. Insert your micro SD card in the direction as shown. Remove your Micro SD Card 1. Push and release the micro SD card. This will unlock the card. 2. Pull out the micro SD card.
Specifications Processor Intel Bay Trail-T Z3735D Quad core (4C/4T) 1.33 GHz (Burst to 1.83GHz) 2MB L2 Cache Memory DDR3L-RS 1333 Default 2 GB Storage Single eMMC up to v4.5.1 Default 32GB Wireless Wi-Fi 802.11 b/g/n +BT4.0 10.1-inch 1280 x 800 LCD Support 5-points multi-touch Front HD camera: 2.0 M Rear HD camera: 2.0 M 2Cell 1S2P Li-polymer 7600 mAh 1 x micro-USB 2.0 port (Type B) 1 x USB 3.
Speaker & Mic Build-in Speaker x 2 Internal Digital MIC x 1 AC-Adapter DC Output: 5V/2A/10 Watt Input Voltage: 100 ~ 240VAC Input Frequency: 47 ~ 63Hz Dimension (mm) 268 (W) x 179 (H) x 10.
