User's Manual

DECLARATION OF CONFORMITY 07
Declaration of conformity
Hereby, Realtrack Systems declares that this product is in
compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU.
To view the full Declaration of Conformity, see the Realtrack
Systems Web Site for your WIMU PRO product:
www.realtracksystems.com/certificates/conformity.pdf
CE Compliant
This product complies with the Directive on Electromagnetic
Compatibility and with the Low Voltage Directive.
Regulatory Information FCC
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
RF exposure safety
This device complies with the FCC RF exposure limits and
has been evaluated in compliance with portable exposure
condition.
The exposure standard for wireless mobile phones employs
a unit of measurement known as the Specific Absorption
Rate, or SAR.
This device has been shown to be capable of compliance for locali-
zed SAR for uncontrolled environment/general population exposure
limits specified in ANSI/IEEE Std. C95.1-1992 and has been tested in
accordance with the measurement procedures specified in FCC RF
Exposure guidelines and IEEE Std. 1528-2013.
The standards include a substantial safety margin designed to assure
the safety of all persons, regardless of age and health. The standard
incorporates a substantial margin of safety to give additional protec-
tion for the public and to account for any variations.
There is no limitation as to which distance can be used from the
human body.
Class B device notice
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.