User Manual

44 / 87
4 Hardware Installation
4 Hardware Installation
4.1 Installation instructions for the WIMAN Access-
radio modem
The following sections deal with the installation of a WIMAN
ACCESS radio modem on a single PC containing the operating
system Windows.
Linking to a LAN requires an experienced network administra-
tor. The method of installation depends strongly on the type of
LAN
4.1.1 Setup of the WIMAN radio modem with Indoor-Set
A reception test must be successfully completed for accurate set-
up (see chapter 5, on page 55)
Checklist:
You will need the following equipment:
PC/laptop with 10 Mbit/s Ethernet Network interface card
(TP-RJ-45-interface) and an available COM port,
Frame Relay router with X.21 and Ethernet interfaces (in-
clusive X.21-link cable),
Crossover cable with RJ-45-interface,
Hybrid-cable type H1-X21C-37,
WIMAN radio modem and indoor set.
It is advisable to execute the setup of the indoor installation in
following order:
1.
Install the antenna to the base foot and connect the antenna
lead to the antenna.
2.
Connect the antenna cable and the Hybrid-cable to the
WIMAN.
3.
Connect the X.21-cable of the Router to the Hybrid-cable
and the crossover cable with the network card of the com-
puter.
4.
Connect the power cable of the WIMAN with the included
24V power supply. Connect the power supply of the
Router.