User Manual

40 / 87
3 Configuration of the WIMAN radio modem
Proceed as shown in Chapter 3.4.1 on page 36
3.4.4 Setup of the other parameters
The only other parameters are
PS1
and
SyncMode
(see page 25)
.
Note:
In order to avoid disturbances of the current line operation, only
qualified personnel in arrangement with the Provider may exe-
cute these adjustments.
Proceed as shown in Chapter 3.4.1 on page 36
3.5 Modification of the WIMAN Passwords
This section deals with the configuration of the passwords of the
WIMAN radio modem. Before you alter the factory-installed
preset passwords make sure to jot down the new passwords and
store them in a safe place.
3.5.1 Setting of a Password for the Authorization Level
one (console)
To change/set a password for the authorization level one:
1.
Access the command line level one. If the command line
prompt appears (for example:
WIMAN II >
), proceed to
No.2.
If you are asked for a password, e.g.:
Enter password: ****
Type in the correct password and press the ENTER-
key. Now the command line prompt should appear, for
example:
WIMAN-II > _
Information:
The following instructions can be issued likewise from all
higher authorization levels.
2.
Change from the command mode of the authorization level
one (indicated by the character " > " at the end of the com-
mand line prompt) into configuration mode by entering the
command
config
.
The command prompt of the configuration-mode appears:
WIMAN-II (config) >
3.
Type in the command
passwd console
and press
ENTER
.
You are now asked to type in a password: