User Manual

36 / 87
3 Configuration of the WIMAN radio modem
3.3 Access to the command line prompt via the
X.21-interface
Will be created later
3.4 Setting of the Parameters of the Differnt Inter-
faces
3.4.1 Setting of the Parameters for the Wireless Interface
The settings of the parameters for the wireless interface can be
divided into the following two categories:
•
base parameter and
•
extended parameters.
The base parameters
destination
(see page 17),
LoopTest
(see
page 19),
NetId
(see to page 19) and
NodeId
(see page 19) can
be modified already in authorization level one (e.g. by the final
customer).
The extended parameters (all remaining parameters in section 2,
on page 38) can only be modified in authorization level two.
To set the base parameters for the wireless interface:
Checklist:
You need the values of the parameters
destination (only LINE)
,
NetId
and
NodeId
. To obtain these values please check with
your Provider.
1. Access the command line level of the authorization level
one (see chapter 2) and change into the configuration mode
by entering the
config
-command. You will receive a simi-
lar display output (depending on the prompt configured)
like:
WIMAN-II (config) >