User Manual

33
/
87
l
3 Configuration of the WIMAN radio modem
3 Configuration of the WIMAN radio mo-
dem
To adjust the WIMAN to your specific network needs it is nec-
essary to modify some of the factory-installed preset parameters.
This modification of the WIMAN can be executed via three dif-
ferent types of interfaces:
•
the wireless interface
•
the RS-232-interface
•
the X.21-interface.
Access to the command line level via the serial RS-232-interface
can take place with the help of a terminal program without pre-
vious configuration of the WIMAN. The access to the command
line level via the wireless interface and the X.21-interface re-
quires a previous configuration of the WIMAN.
3.1 Access to the Command Line Level over the
Wireless Interface
To access the command line level over the wireless interface
you have to use a TELNET-Program like NETTERM or the
like. Just enter the correct IP-address of the WIMAN you want
to administer and connect. You will receive the same display as
if connecting via a serial cable.
The big advantage is that you can connect to any WIMAN, no
matter where it is situated, and that you have the same function-
ality as when connecting directly via cable.
Checklist:
To access the WIMAN radio modem via the wireless-interface
you need:
•
A Terminal program (Telix, Hyperterm, etc.),
•
A PC/Laptop with an online connection
•
A properly configured WIMAN unit