User Manual
2 The WIMAN Command Line Level
26 / 87
When selecting a password, be sure to use the designated char-
acters only (see page 14). For instructions on how to set up a
password for authorization level one, see Chapter 3.5.1, page 40.
The instruction
del Passwd console
deletes the password for
authorization level one (console). For mor information see
Chapter 3.5.2, page 41.
The instruction
passwd enable
permits the designation of a
password for access to authorization level two (Enable). When
entering the password, be sure tu use the specified characters
only (see page 14). For instructions on how to set up a password
for authorization level two, please refer to Chapter 3.5.3,
page 40.
The instruction
Enabl
e enables you to switch from the instruc-
tion mode of the authorization level one into the command mode
of the authorization level two (see page 25). To enter the
authorization level two a password is always required.
2.6.2 Instructions for manipulating and transferring of
Configuration Data
The instruction
Checkcfg
checks if all the parameters are valid
and entered correctly. This instruction can only be issued in con-
figuration mode.
The instruction
Config
enables to change from the command
mode of the respective authorization level into the configuration
mode (see page 25). A successful transition into the configura-
tion mode is displayed by the term
(config)
behind the com-
mand-line prompt and before the indication of the authorization
levels (located in parentheses). The following example shows
the factory-installed command-line prompt for authorization
level two:
WIMAN II (config) #
Del Passwd
console
Enable
Config
Passwd enable
checkcfg