User Manual

48 / 90
4 Hardware Installation
- Use the j-shaped wall mount if you are installing the
WIMAN on the side of the building directly facing the ra-
dio tower.
Use the aluminum mast mounting kit if you are installing
the WIMAN not facing the radio tower directly due to an
obstacle (e.g. rear side of a wall etc.).
Use the tile roof mounting set if you are installing the
WIMAN to a roof with roofing tiles.
4.1.7 Second Reception Test
Perform a second reception test to ensure that the selected place
of installation and the selected adjustments offer a sufficient ra-
dio reception.
Separate the current supply and the RS232-plug from the Hy-
brid-2-cable on the WIMAN radio modem.
Further information of the execution of a receipt test can be ob-
tained in chapter 5 on page 55.
After the radio test is completed, reconnect the current supply
and the RS232-plug to the Hybrid-2-cable on the WIMAN.
4.1.8 Installation of the data cable
With some installations, it is possible to use a prefabricated ca-
ble of desired length with two 25pin Sub-D plug connectors.
However, this is not possible with most installations. If no pre-
fabricated cable can to be used, it is advisable to attach a plug
connector at one end of the cable prior to installation.
Lay the data cable from the outside inward. Make sure the end
with the 25pin Sub-D connector is outside. It is substantially
simpler to solder the second plug connector on in the internal
area than in the external area.
Be sure that the data cable is sufficiently fixed to the mounting
sets, the mast and to the wall.
Wind up all surplus cables and stow them away. Wind the cable
up in one or two turns. This measure serves as additional light-
ning protection for the router.
4.1.9 Mounting of the DB25-plug interfaces at the inside
end of the data cable
Solder the two 25pin plug connectors to the data cable according
to the pin allocation plans specified in chapter 10.