User Manual

47 / 90l
4 Hardware Installation
Be sure to discuss the details of installation with the cus-
tomer in respect to the local construction and homeowner
regulations.
4.1.5 First Reception Test
This first reception test serves to determine if the optimum field
strength can be obtained from the installation place and adjust-
ment of the WIMAN outdoor sets.
Further information about reception tests can be found in chap-
ter 5 on page 55.
4.1.6 Installation of the Attachment Set and the Outdoor
Housing
To set up the outdoor housing:
1. Assemble the outdoor housing.
2. Attach the antenna to the outdoor box with the plug facing
down.
3. Loosen the four screws on the front of the outdoor housing
and remove the cover.
4. Loosen the four fixing bolts for the WIMAN mounting
plate on the inside and remove it.
5. Place the WIMAN inside the housing with the LEDs facing
upwards and the backside (with the connector) towards the
opening of the housing.
6. Lead a cable strap through the two holes in the mounting
plate (the cable strap later serves for the attachment of the
hybrid cable of the type 3).
7. Secure the mounting plate above the WIMAN.
8. Connect the appropriate ends of the hybrid cable of the
type 3 with the 37Pin Sub-D-interface and to the current
supply link.
9. Place the excess cable in the space between the WIMAN
and the outdoor housing in such a way that the 25pin plug
connector is hanging over the front the mounting plate.
10. Connect the data cable with the hybrid cable and secure the
plug connectors with the cable strap. To ensure positive
connection at all times, install 2 hex nuts between the con-
nectors.
11. Use the screws, wearing parts and pegs to install the appro-
priate attachment set onto the roof or at the wall.