User Manual

45 / 90l
4 Hardware Installation
Note:
There is no power switch on the WIMAN. The connection
is successful when the operational status indicator on the
front side of the WIMAN lights up green.
5. Connect the RS-232-interface to the computer interface. If
you use the serial interface of a PC or Notebook, please re-
fer to the configuration specified in Chapter 3 on page 33.
As soon as it is attached to the power supply, the WIMAN
ACCESS begins to boot and starts to search for the proper
WIMAN STAR. When the synchronization signal is received,
the Status LED begins to light up green.
If the status indication does not light up, no data can be transmit-
ted or received.
If this occurs, separate the WIMAN from the power supply and
then reattach it. If the status indicator still does not light up,
please consult your Internet Provider for support.
4.1.2 Setup of the Outdoor-Set
4.1.3 Required material
Checklist:
The following material should be supplied from your Distribu-
tor:
WIMAN radio modem,
WIMAN power supply,
Router (optionally),
25 pin loop-back cable
Outdoor Set consisting of:
-
Outdoor-box with security clips,
-
Planar Antenna,
-
Antenna cable, 50cm,
X21-Hybrid-cable-set consisting of:
-
Hybrid-cable, type 2,
-
Hybrid-cable, type 3,
-
Socket 25pin and housing (2x each),
Data cable, 12pin, length depending on installation,