User Manual
43 / 90l
3 Configuration of the WIMAN radio modem
When accessing the command line prompt of authori-
zation level one the following prompt will appear::
Enter password: ****
Enter the password for the authorization level two (pay
attention to upper- and lowercase characters).
The command line prompt should appear, e.g.:
WIMAN-II #
2. Change from the command mode of authorization level two
(indicated by the „#“- sign at the end of the command line
prompt) into the configuration-mode by entering the com-
mand config.
The command line prompt may look as follows:
WIMAN-II (config) #
3. Enter the command passwd enable and press ENTER.
4. You are now asked for entering a password:
Enter password:
5. Enter the password.
Note:
Please note that passwords are case-sensitive.
Each typed-in character will be shown on the screen as a
„*“. The already existing password will be overwritten.
The entered password will be stored in the new configura-
tion but is not set active yet.
6. Leave the configuration mode by entering the command
exit (see page 17).
7. Proceed as shown in chapter 3.4.1 on page 36.
3.5.4 Deletion of a password of the authorization level
two (Enable)
A password for authorization level two (Enable-mode) is always
required and cannot be deleted. However, it can only be changed
(see 3.5.3, on page 42)